Buspirone, Urine
Buspirone is an azaspirodecanedione drug used primarily for its anxiolytic properties. Buspirone is very similar to benzodiazepines in its effect. However, unlike benzodiazepines and zolpidem, buspirone does not mediate its CNS-depressant activity through GABA receptors. The specific mechanism of action remains unknown, although the drug does interact with serotonergic (5-HT1A and 5-HT2) and dopaminergic (D2) receptors. Typical route of administration is oral. The major metabolites of buspirone are 6-hydroxybuspirone and 1-(-2pyrimidinyl) piperazine (1-PP), which are both pharmacologically active. The 1-PP metabolite is further metabolized by hydroxylation and may be conjugated. The half-life of buspirone varies between 3-12 hours but is typically less than 6 hours.
A single oral dose is primarily eliminated within 24 hours, with half or more appearing in the urine as metabolites. Actual elimination depends on factors such as drug formulation dose, dose frequency, clinical status and pharmacokinetics of the individual patient.
Common side effects: dizziness, drowsiness, light-headedness, headache, and nervousness. Overdose effects include nausea and vomiting, seizures, miosis, coma, and possible death.
Buspirone and metabolites are not widely monitored, but it can be detected in urine by a variety of analytical methods (see below); both qualitative and quantitative tests are available.
- Adherence monitoring
- Drug abuse evaluation
- Toxicity/Overdose assessment
Therapeutic levels: <0.01 mg/L
Toxic levels: Data not available
Note: therapeutic ranges and toxic thresholds are best evaluated from blood samples. Quantitative results obtained with blood samples collected at specific times after drug administration are preferred for pharmacokinetic analyses.
Cut-Off Ranges
Cut-off values are used to determine the positivity of the urine specimen being analyzed. Cut-off values can vary based on the particular method of analysis that is used for detection, whether the test is a qualitative method or a quantitative method. Detection will be improved with low cutoff concentrations. The testing laboratory cut-off range is listed on the patient report.
Fresh urine specimen (random) collected in either a clean glass or plastic container. An acceptable urine specimen submitted for testing should be in the pH range of 3-11. Creatinine or specific gravity results will identify dilute specimens. Adulteration of the urine specimen can result in erroneous results.
Stability
- Ambient: 5 days
- Refrigeration: 7 days
- Frozen: 30 days
- Baselt RC (ed). Disposition of toxic drugs and chemicals in man, 9th ed. Seal Beach, CA: Biomedical Publications; 2011.
- Mead Johnson, Pharmaceuticals. Buspar (buspironehydrochloride) prescribing information. Princeton, NJ; 2002Feb.